Trijicon RMR Sight Mount for Sig Sauer P220-229, 320
THIS MOUNT DOES NOT WORK WITH ANY SIG OPTICS READY PISTOLS (P320 X-CARRY ETC.)
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780″
Overall Width: 1.1″
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR, Holosun HS507C
This mount fits (including but not limited to):
Sig #8 Sights
Bersa Thunder UC Series (9/40/45)
Bersa Thunder HC Series (9/40/45)
This mount does not fit:
Any Optics Ready Sigs i.e. P226 Legion RX, P229 RX, P320 X-Carry etc.
P365 (The dovetail cut is too deep to work with our mount)
FN 509 Tactical
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
– Remove the rear sight*
– Install the EGW Sight Mount in the dovetail
– Tighten set screw (if applicable)
– Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
– Apply blue Loctite to the provided mounting screws
– Torque mounting screws to 15in/lbs
2 Flat Head Cap Screws – Provided for Trijicon RMR
The screws that are included with this mount require a 5/64” allen wrench for installation.
Click here to see a video from Vortex on how to install our red dot base on a slide.