Description
Description
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604″
Overall Width: .99″
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, Optima
This mount fits (including but not limited to):
Sig #8 Sights
P220
P224
P225
P225-A1
P226
P227
P228
P229
P238
P239
P245
P320
P938
SP2022
M11-A1
MK25
Bersa Thunder UC Series (9/40/45)
Bersa Thunder HC Series (9/40/45)
FN 509
This mount does not fit:
Sig 1911s
Any Optics Ready Sigs i.e. P226 Legion RX, P229 RX, P320 X-Carry etc.
P210 Target
P365 (The dovetail cut is too deep to work with our mount)
Our sight base is compatible with Sig #8 rear sight cuts. Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions
– Remove the rear sight*
– Install the EGW Sight Mount in the dovetail
– Tighten set screw (if applicable)
– Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
– Apply blue Loctite to the provided mounting screws
– Torque mounting screws to 15in/lbs
Modification of your firearm may nullify the manufacturer’s warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
